2015 Tesla Model X
reported issues, recalls & what to inspect
This report uses official federal safety records plus VeroRoad’s vehicle × tool evidence. It is a screening tool, not a reliability grade or prediction that your specific car will fail.
NHTSA complaints are consumer-submitted allegations, not verified failures. Raw complaint totals are not failure rates because vehicle sales/exposure are not normalized here. A recall is an official safety campaign, but your VIN may or may not be included.
Which systems appear most often in the complaint record?
Use this to prioritize inspection effort, not to label the vehicle “good” or “bad.”
That does not prove the vehicle has no problems. Use the exact VIN, service history and an independent inspection.
Where were mileage-at-failure values reported?
NHTSA did not return enough usable mileage values for a timeline.
Official campaigns returned for this model-year query
Open the exact VIN before purchase to determine whether a campaign applies and whether the remedy was completed.
20V062000STEERING:ELECTRIC POWER ASSIST SYSTEM
Tesla, Inc. (Tesla) is recalling certain 2015-2016 Model X vehicles. The aluminum bolts that attach the power steering gear assist motor to the gear housing may corrode and fracture causing a reduction or complete loss of power steering assist.
Why it matters: Loss of power steering assist would require a higher steering effort, especially at lower speeds, which may increase the risk of a crash.
Remedy: Tesla will notify owners, and Tesla Service Centers will replace the steering gear mounting bolts with coated steel bolts, and add a corrosion-preventative sealer to the steering gear motor housing and motor connection bolts. If the mounting bolts are found to be broken or break during removal and cannot be removed, a new steering gear will also be installed. All services will be performed free of charge. The recall began February 15, 2021. Owners may contact Tesla customer service at 1-877-798-3752.
Reported 05/02/2020 · Verify exact VIN applicability.24V376000SEAT BELTS:FRONT:WARNING LIGHT/DEVICES
Tesla, Inc. (Tesla) is recalling certain 2012-2024 Model S, 2015-2024 Model X, 2017-2023 Model 3, and 2020-2023 Model Y vehicles. In the event of an unbelted driver, the seat belt warning light and audible chime may not activate as intended. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 208, "Occupant Crash Protection."
Why it matters: A seat belt warning system that fails to alert occupants of an unbelted seat belt can increase the risk of injury during a crash.
Remedy: Tesla will release an over-the-air (OTA) software update. Owner notification letters were mailed July 26, 2024. Owners may contact Tesla customer service at 1-877-798-3752. Tesla's number for this recall is SB-24-00-008.
Reported 28/05/2024 · OTA remedy noted · Verify exact VIN applicability.What I would inspect before money changes hands
The highest reported component groups are converted into inspection tasks. They are not diagnoses.
Baseline vehicle inspection
- Cold start, road test and full-system scan
- Check fluids, leaks, tires, brakes and battery
- Review maintenance, collision and recall history
Make it harder for a recently cleared warning light to fool you.
A clean dashboard is not the same as a clean scan. Readiness monitors, pending codes and permanent codes provide useful context during a pre-purchase inspection.
- Run a full-system scan before clearing anything
- Read current, pending and permanent powertrain codes
- Check readiness monitors; multiple “Not Ready” monitors can be consistent with a recently cleared ECU or disconnected battery
- Save freeze-frame data for any stored emissions/powertrain fault
- Scan ABS, SRS, transmission and body modules when the tool supports them
- Check 12V battery / charging condition because low voltage can create misleading module faults
Look beyond recalls.
Manufacturers submit service bulletins, warranty extensions, repair instructions and other communications to NHTSA. These documents can reveal service procedures and known conditions that are not necessarily safety recalls.
Tools that intersect this inspection path
These recommendations use VeroRoad’s existing exact vehicle/function evidence. Fit comes before price.
Autel MaxiCOM MK900-BT
Intersects 4 functions used in this inspection path.
XTOOL D8 (2026)
Intersects 4 functions used in this inspection path.
Autel MaxiCOM MK900-TS
Intersects 4 functions used in this inspection path.
TOPDON ArtiDiag900 Lite
Intersects 4 functions used in this inspection path.
Useful supporting equipment
A scanner cannot replace physical inspection and measurement. These tools cover common gaps.
Professional battery and resistance testing with sequence testing for higher-volume work.
Check price on Amazon →Useful for locating abnormal heat in electrical, mechanical and EV-related troubleshooting without assuming it is mandatory for every job.
Check price on Amazon →Adds multimeter and current-clamp measurements for deeper electrical troubleshooting when paired with supported MaxiBAS tools.
Check price on Amazon →Dedicated TPMS workflow plus diagnostics and service functions; strong fit when TPMS is a frequent shop job.
Check price on Amazon →Tesla Model X Risk Radar by year
Where these signals come from
Federal data are fetched from NHTSA’s public APIs. VeroRoad aggregates the records into screening signals and keeps complaints separate from confirmed recalls.